2026 Demon Tweeks Motorsport Catalogue - Flipbook - Page 315
from
1
£205.50
CARTEK Battery Isolators are designed to perform two
functions in accordance with FIA regulations.
FEATURES
These are:
1) Stop the Engine from running.
2) Disconnect the Battery from ALL electrical systems.
• Fully electronic with no moving parts
• Totally sealed against water and dirt
• Completely resistant to shock and vibration
• Fully integrated with built in alternator run-down circuitry
- No extra components required
• Driver operation by a single internal ON-OFF button/switch
• External operation by single or multiple ‘strike’ button(s)
• Buttons / switches connected to Isolator using light weight
wiring
• Mounts close to battery for reduced cabling
• Very small and weighs just 70g - 120g
• Designed and manufactured in UK using the latest and best
quality components available
They do this by firstly disconnecting power to the ECU or
Ignition circuit - forcing the engine to stop and electrical
power generation by the alternator/generator to cease.
Then secondly, the Battery Isolator disconnects the
negative side of the vehicle’s battery from chassis/ground,
thereby disconnecting the battery from ALL of the car’s
electrical systems.
Load dump protection is built in so no additional
components are needed.
Meets FIA and Motorsport UK Safety Regulations.
from
2
from
£217.50
3
1 • GT Battery Isolator
2 • X-Pro Battery Isolator
3 • X-Club Battery Isolator
The X-PRO Battery Isolator is designed to handle the high
cranking currents of large capacity and high-performance race
engines. Configurable Engine Kill output (5A - 20A selectable).
Signal connections via sealed Deutch DT connector.
Designed to be a ‘cost effective’ version of Cartek’s Battery Isolators. This device is suitable for cars of medium tune/performance
and engines up to 3.0L V6, turbo or NA. Ideal for one-make championships with stock-based engines, e.g. Audi TT Cup, Type R Trophy,
MX5/Eunos Championships, Clio Cup, Mini Challenge etc. Engine
Kill signal is a fully protected 10A power output for connection to
ignition coils, engine relay or ECU/PDM input.
Battery Isolator X-CLUB unit only.
(CK-BXC-01)
£159.50
Battery Isolator X-CLUB Complete Kit. (CK-BXC-06)
£199.50
(Includes waterproof internal and external switches.)
The GT Battery Isolator is suitable for almost all race and rally car
applications. Incorporating 600A battery isolation and fully protected
Battery Isolator X-PRO unit only.
(CK-BXP-02)
£217.50
40A power output for connection to ECU, ignition or fuel system.
Battery Isolator X-PRO Complete Kit. (CK-BXP-05)
£259.50
Battery Isolator GT unit only
(CK-BT-02)
£205.50 (Includes waterproof internal and external switches.)
Battery Isolator GT Complete Kit
(CK-BG-06)
£245.50
(Includes waterproof internal and external switches.)
X-PRO TECHNICAL SPECIFICATION
GT TECHNICAL SPECIFICATION
93 x 50mm
120g
600A (2000A Peak)
40A protected
Flying Leads
Size:
Weight:
Battery/cranking current:
Engine kill output:
Connection:
£159.50
X-CLUB TECHNICAL SPECIFICATION
69 x 58mm
110g
650A (2000A Peak)
5A-20A protected
DEUTCH DT06-4S
Size:
Weight:
Battery/cranking current:
Engine kill output:
Connection:
BATTERIES • I S O L AT O R S
SOLID STATE BATTERY ISOLATORS
CARTEK solid state Battery Isolators are very small
and highly reliable alternatives to the traditional
mechanical master-switch. They have been
designed to overcome all of the problems and
restrictions associated with mechanical and electro/
mechanical master switches to maximise safety,
save weigh and simplify installation.
64 x 49mm
78g
400A (1500A Peak)
10A protected
Flying Leads
Size
Weight:
Battery/cranking current:
Engine kill output:
Connection:
from
4
BATTERY ISOLATOR ACCESSORIES
£25.50
(only use with Cartek Products)
£7.50
5
4 • External Kill Button
Fully sealed with flying leads.
Red
(CK-EP-02)
£25.50
Blue
(CK-LP-03)
£25.50
Yellow
(CK-YP-04)
£25.50
Fire extinguisher button
(CK-FP-04)
£29.50
5 • Kill Button Shroud
6
6 • Safety
Stickers Pack
Available in blue, red and yellow
for item 4
(CK-CP)
£7.50
£675.00
£24.50
£78.40
7 • External Kill Button
8 • Internal Kill Button
Red metal fully sealed kill switch
upgrade. Can also be used as a stand
alone switch with other kill switches.
(CK-EM-03)
£78.40
This sealed push button switch
is for driver operation of Cartek
Battery Isolators only
CK-LT-01) £24.50
MINI POWER DISTRIBUTION MODULES
Standard
from
9
7
Includes one internal
and one external
safety sticker.
(CK-SS-03)
£8.95
POWER DISTRIBUTION PANELS
Retro
8
£8.95
10
NEW
£239.50
NEW
11
£255.00
9 • Power Distribution Panel
A fully integrated, fully electronic solution to power distribution in race and
rally cars. Designed to replace 8/16 fuses, relays and switches as well as a
variety of control systems, these units therefore greatly simplify the wiring,
reducing build time, saving weight and maximising reliability. Cartek have
now also produced a retro edition Power Distribution Panel for classic cars
that want modern electronics.
How It Works: The Power Distribution Panel takes +12V power directly from
the battery then distributes this to all the electrical systems around the car.
All 8/16 power outputs from the Power Distribution Panel are controlled
from the front panel push buttons or from external switches and inputs. All
power outputs are fully protected with 6 selectable current settings thereby
completely removing the need for fuses or circuit breakers. The function of
each channel is also selectable from a choice of 8 different options.
(CK-PDP) from £675.00 - more information online
ALL PRICES PLUS VAT
• NEW Mini Power Distribution Modules
A lightweight, compact module that replaces fuses, relays, and circuit breakers across five independent circuits (4 on the
CAN-Bus model). Each channel is configurable up to 20A with integrated protection, simple pushbutton setup, and no
need for laptops or extra tools.
Features:
• 5 configurable outputs up to 20A each
(4 on CAN-Bus model)
• Small and lightweight (52 x 35mm)
• Push button setup – no laptop required
10 5 Channel Model
11 4 Channel CAN-Bus Model
• Overcurrent and short-circuit protection
• Soft-start for fans/pumps
• CAN diagnostics and RGB status LEDs
• Includes crimps and connectors
(CK-PDM-05)
(CK-PDM-04C)
£239.50
£255.00
• SHOP ONLINE • www.demon-tweeks.com • SALES ORDER HOTLINE • 01978 664466 •
315
